Everyone should know the importance of LED bulb housing injection blowing machine. High-quality maintenance can make the performance of the equipment reach a better level, so that it can run and produce high-quality blow molding products. Do you know how the LED bulb housing injection blowing machine equipment is maintained? What is included in the maintenance of LED bulb housing injection blowing machine equipment?Today, Baiya will share with you the maintenance methods of LED bulb housing injection blowing machine equipment.
1.Inspection of Machine Assembly
If it is a newly purchased LED bulb housing injection blowing machine, inspection of machine assembly should be carried out. After the equipment is installed according to the requirements of the manual, the entire unit should be calibrated, including the alignment of the extruder head and the clamping device; install the mold water cooling pipe and check whether the direction is correct; whether the operator and the control device are convenient to operate ;Whether the feeding, placement of finished products, recycling process of waste products is smooth without affecting normal operation, whether the location of related auxiliary equipment is appropriate, etc. Only after the inspection results of equipment assembly meet the production and safety requirements, the equipment is in the best assembly state.
Inspection of hydraulic and lubrication systems Check the hydraulic oil level gauges of the extruder and each hydraulic device to keep the oil in the oil tank above the reference oil level.
2.Daily Maintenance Inspection
1. Before the start of each shift, lubricating oil must be added to the moving parts of the manipulator, manipulator guide rail, and mold opening and closing guide rail once, and the swing arm should be added once every 3-4 days. Frequently check whether the reducer of the main engine and the reducer of the heating machine are short of oil for production Before checking whether the moving parts are firm, whether the screws are loose and falling off, especially where the impact force is strong, and whether the belt transmission part is abnormal.
2. Check whether the high-pressure air source, low-pressure air source, power supply, and water source are normal. Check whether the emergency stop switch, safety door switch, and protection device detection switch are normal. , whether the action is sensitive, check whether the triplet is abnormally leaking, whether it is blocked, whether the water storage capacity of the water cup is too full.
3. When turning on the high and low pressure air source switch, you must move slowly to prevent the air flow rate from being too fast and dirt from blowing into the solenoid valve. At the same time, open the exhaust valve for 30 seconds to ensure that the air is clean.
4. When the machine is started, it must be confirmed that the mechanical part is in good condition, there is no one inside the machine, and there is no foreign object. Especially the position of the handle, so as not to hurt people. Close the safety door at the same time.
5. When starting the machine, the motor must be started first, and the heating machine should be delayed for 30 seconds to prevent voltage fluctuations. Make sure the cooling water is turned on before starting heating.
The maintenance of blow molding machine equipment is to optimize the performance and status of each part and each component, so that each part can achieve better performance and working condition. In order to optimize the overall performance of the blow molding machine equipment, prolong the service life of the equipment, and save the operating cost of the blow molding machine equipment.
Do You Need LED Bulb Housing Making Machine?
Baiya Machinery is a professional LED bulb housing injection blowing machine manufacturer, specializing in providing the best LED housing molding solutions for overseas customers. Provide them with state-of-the-art lampshade forming machines.
Our LED bulb housing injection blowing machine is reasonably priced, excellent in quality and powerful in function. If you are a manufacturer of LED enclosures or a manufacturer of LED lights, then our machines are the products you should consider.
Contact us now, we will provide you with reasonable quotation and solutions!
